How it works
How does Natupol Excel Start Up work?
After their release, worker bumblebees start pollinating the crop. They are supported by more workers born in the weeks after their introduction.
The improved visibility of the hives among the crop (Beevision) is based on the way bumblebees see. Bumblebees now easily find the hive, fewer bumblebees get lost in the greenhouse and pollination improves.
One hive with one colony of bumblebees including a queen, 100-125 workers, brood and sugar water
Directions for use
Application Natupol Excel Start Up
- Distribute the Natupol hives evenly along the main path of the greenhouse
- Place the colonies on a horizontal platform (avoid inclination, otherwise sugar water may leak)
- During summer; Position the hive about 20-60 cm above the ground on the south-side of a path to obtain maximum shade from the crop. If needed, provide additional shading.
- During winter; Position the hive near the top of plants on the north side of the main path. Ensure that the hive is exposed to the first daylight.
- Wait at least for 15 minutes after positioning the hives before opening the hive entrance, this allows the bumblebee colonies to calm down.
Best working conditions Natupol Excel Start Up
Natupol performs best at ambient temperatures of between 10-30°C
Special points of attention
- Make sure the hives and the entrances are well visible, so the bumblebees easily find their way home.
- Place no more than two hives next to or close to each other. To reduce drift of bumblebees, make sure each hive entrance points into a different direction.
- Please note that direct sunlight on the hive can increase the internal hive temperature with 5-15°C. It is important to provide shade in warm conditions.
- Make sure ants cannot reach the sugar water of the hive by making a barrier of grease or insect glue. Also avoid contact between plants and the hive, so that ants cannot reach the hive.
- Avoid colonies to be placed in the direct surrounding of the CO2 supply, or in other locations where CO2 can reach high levels (over 2500 ppm).
Find out which pesticides have side effects on this product
Use and Hygiene
- Never move a hive from one greenhouse to another
- Prevent bumblebees from leaving the greenhouse
- Remove bumblebee hive 6-8 weeks after introduction
- Clean the hive stand before placing new hives
- Seal old hives into plastic bags and dispose them according to local legislation.
"The general conditions of Koppert (Koppert B.V. and/or of its affiliated companies) apply. Only use products that are permitted in your country/state and crop. Check local registration requirements. Koppert cannot be held liable for unauthorized use. Koppert is not liable for any loss of quality if the product is stored for longer than recommended and/or under incorrect conditions."