Rollertrap

Type:
Sticky ribbon with wet glue
Type:
Sticky ribbon with wet glue
Product category:
Monitoring
  • For trapping flying insects

  • Especially for areas where high pest pressure is expected

P3191786.jpg
  • For trapping flying insects

  • Especially for areas where high pest pressure is expected

Use for

Use for

For trapping whiteflies, thrips, leaf miner and fungus gnats in hot spots or places where high pressure can be expected, such as along gables, ventilation windows and (other) draughty places.

Pests

Whiteflies, thrips, leaf miners, fungus gnats.

How it works

How it works

Mode of action

Insect pests are attracted to the colour of the sticky trap and get caught in the glue.

Product specifications

Product specifications

Presentation

Polyethylene ribbon coated with wet sticky glue.
 

Available colours and sizes

Colours:
yellow, blue, white, red, black and transparent

Standard sizes:
5, 10, 15 and 30 cm x 100 m 
15 cm width is also available in lengths of 125, 150 and 500 m; other lengths on request

Directions for use

Directions for use

Presentation

Make sure that the Rollertraps are at least a room temperature before placing them. The glue will be softer and the traps will unroll easier.

Application

  • Place Rollertraps in areas where high pest pressure is expected, such as along gables, near ventilation windows and at (other) places with dry conditions
  • Rollertrap should be hung above the crop when the crop is still low 
  • Attach the Rollertrap to crop wires, greenhouse poles, or other supportive structures
  • Place the Rollertrap approximately 25 cm above the crop, except for the 30 cm width which needs to be placed 40 cm above the crop
  • To assist with placement, insert a rod or other expedient through the center opening of the roll which will allow the Rollertrap to spin freely while unrolling
  • At the beginning and end of each run, cut the trap approximately 40 cm longer than the support structure. Wrap the extra around the support and secure with staples or clips. It may be necessary to secure the Rollertrap mid run to provide additional support.
  • It is recommended to replace the Rollertrap after 10 months, or earlier if the surface is largely covered by insects and/or debris
  • For additional recommendations and rates, contact your local Koppert representative or distributor

The information given below is merely indicative. Tailored advice can be provided if information is available on the local factors that need to be taken into account, such as the crop, the climate conditions and the level of infestation. For the correct approach, please consult a Koppert specialist or a recognized distributor of Koppert products.

Rollertrap preventive light curative heavy curative
<p>One Rollertrap per 1 to 3 plant rows.</p>

Timing

In high crops Rollertraps should preferably be installed when the crop is still low, just before or after planting. 

Product handling

Product handling

Storage time

See Best before date.

Storage temperature

0-32°C/32-104°F.

Storage conditions

In a cool, dry place.

"The general conditions of Koppert (Koppert B.V. and/or of its affiliated companies) apply. Only use products that are permitted in your country/state and crop. Check local registration requirements. Koppert cannot be held liable for unauthorized use. Koppert is not liable for any loss of quality if the product is stored for longer than recommended and/or under incorrect conditions."

Need help?

Get in touch with the expert

Want to know more about our company and products? Get in touch with one of our experts.
Please allow 24-48 hours for our experts to respond to your inquiry.
We produce our products and solutions for professional growers in horticulture.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service.