Long-tailed mealybug

other filaments is roughly half the width of the body. The female is 3 - 4 mm long. Reproduction in Pseudococcus longispinus , may be sexual or asexual

Casea

if finer than 0.3 mm (50 mesh) Use a maximum pressure of 20 bar/290 psi (on nozzle) The spray nozzle opening should be at least 0.5 mm (500 microns – 35

Neoseiulus cucumeris

side veins. They are oval, white and have a diameter of approximately 0.14 mm. The larvae have six legs, are the same colour as the eggs, and are only slightly [...] legs, are light beige and have a flat, elongated body. They are roughly 0.4 mm in length. Males are smaller than females. Protonymphs, deutonymphs and adults

Amblyseius swirskii

often in the axil of veins. They are oval, white and are approximately 0.14 mm in diameter. The larvae have six legs, are the same colour as the eggs, and [...] translucent white in colour, and have a flat, elongated body. They are roughly 0.4 mm in length. Males are smaller than females. The mites are very mobile and actively

Larvanem

if finer than 0.3 mm (50 mesh) Use a maximum pressure of 20 bar/290 psi (on nozzle) The spray nozzle opening should be at least 0.5 mm (500 microns – 35

Asian citrus psyllid

Adult Asian citrus psyllids are mottled brown wings insects of about 25 to 35 mm long. The adults are active, jumping/flying insects and can readily fly short

Potato aphid

source. Even the winged forms can be red. Wingless potato aphids are 1.7 - 3.6 mm long, elongated, with a dark longitudinal stripe running along the dorsal

Amblydromalus limonicus

the underside of leaves. They are oval, white, and are approximately 0.14 mm in diameter. The larvae have six legs, are the same colour as the eggs, and [...] translucent white in colour, and have a flat, elongated body. They are roughly 0.4 mm in length. Males are smaller than females. The mites are very mobile and actively

Entonem

if finer than 0.3 mm (50 mesh) Use a maximum pressure of 20 bar/290 psi (on nozzle) The spray nozzle opening should be at least 0.5 mm (500 microns – 35

Capsanem

if finer than 0.3 mm (50 mesh) Use a maximum pressure of 20 bar/290 psi (on nozzle) The spray nozzle opening should be at least 0.5 mm (500 microns – 35