How it works
Mode of action
Predatory mites pierce their prey with their sucking mouthparts and suck out the contents.
|Pack size||125,000 predatory mites.|
|Presentation||6 litre bucket.|
Directions for use
- Mix carefully by turning around the bucket a few times
- Carefully sprinkle on the leaves
- Make sure the material remains on the leaves for at least a few hours after releasing the predatory mites
- Can also be applied with (Mini)-Air(o)bug
The dosage of Anso-Mite depends on climate, crop and pest density and should always be adjusted to the particular situation. Start introduction preventively soon after planting of the crop. Introduction rates typically range from 50-250 per m2/release. Releases should be repeated at least 3 times at weekly intervals or until control is achieved. Consult a Koppert advisor or a recognized distributor of Koppert products for advice on the best strategy for your situation.
Amblyseius andersoni is effective at temperatures above 14°C/57°F. Optimum temperatures are between 20 and 28°C (68 and 82°F). A. andersoni is sensitive to relative humidity below 65%.
Can be combined with Orius spp.. Do not combine with other generalist predatory mites (Amblyseius swirskii, Neoseiulus cucumeris, Amblydromalus limonicus).
Application of this product can cause sensitization or allergic reactions, we therefore advise to take the necessary precautions.
Pesticides can have (in)direct effects on biological solutions. Find out which pesticides have side effects on this product.
Storage time after receipt
In the dark, provide ventilation to prevent CO2 accumulation.
"The general conditions of Koppert (Koppert B.V. and/or of its affiliated companies) apply. Only use products that are permitted in your country/state and crop. Check local registration requirements. Koppert cannot be held liable for unauthorized use. Koppert is not liable for any loss of quality if the product is stored for longer than recommended and/or under incorrect conditions."